Owner’s Manual DMX-512 ADAPTER MODELS LP-DMX3 AND LP-DMX5 FOR YORKVILLE LP-LED4 LIGHT BAR
NOTES: 1. There is no valid DMX-512 address 0. To make the LP-DMX3/ LP-DMX5 work for those who might not want to read the manual, we promoted addre
APPENDIX B DMX-512 TERMINATORS A DMX-512 terminator can be easily built into a cable-mounted male XLR connector, per the above diagrams. A terminato
Dear Customer, Years ago, I approached Yorkville Sound for permission to build and sell an adapter to allow their LP-304 light bars to work with a DMX
Installation The LP-DMX3/LP-DMX5 installation kit should include the LP-DMX3 or LP-DMX5 plug-in module, a 4-wire connecting cable and this manual.
If there is a clamping screw in the stand adapter at the center of the LP-LED4, remove it and set it aside. Make sure the LED pods are level and the
Put the other end of the cable through the knockout hole and connect it to the P3 connector on the LP-DMX3/LP-DMX5. Turn the LP-DMX3/LP-DMX5 over a
Controls, indicators and connectors Mode Switches The two-place DIPswitch to the extreme left selects the operating mode of the combined LP-LED4 and
called for. While operating as a strobe, the intensity and color controls remain in effect. Placing both switches in the “up” position selects mod
“DMX OK” LED The DMX OK LED lights when the LP-DMX3/LP-DMX5 is receiving a valid DMX-512 signal from the controller. If the DMX-512 signal stops for
Appendix A – address switches
Kommentare zu diesen Handbüchern