Yorkville PSA1 Bedienungsanleitung PDF herunterladen (Seite 4)

3. Input Jack

This female-XLR / ¼-inch TRS combi-jack accepts either line level XLR or ¼-inch TRS patch cables.

For best noise reduction use balanced cables. Unbalanced ¼-inch TS cables can be used for unbal-

anced signal sources if needed.

Note: Both ¼-inch and XLR inputs have identical functionality.

4. Link

This XLR male connector can be used with a standard XLR cable to daisy-chain up to ten

PSA1 cabinets without signal degradation. Simply loop from one cabinet’s Link jack to the

next cabinets Input jack.

5. PSA1 Level Control

This control adjusts the volume level of the PSA1 relative to the input signal level. Mixers and other

audio sources connected to the PSA1 tend to have different output voltages, which mean the level

control on the PSA1 is used to ﬁne tune the cabinet’s volume relative to the mixer settings. It is per-

fectly acceptable to set the PSA1 Level above or below the center 0 dB setting. Normal operation will

be between 10 o’clock and 2 o’clock.

6. LF (Low Frequency) Mode Pushbutton Switch

The LF switch allows the user to conﬁgure the PSA1 to be used with or without a subwoofer. In Fullrange

mode, the cabinet’s internal high-pass (low-cut) ﬁlter is set to 40 Hz. When using the PSA1 with a subwoofer,

such as the PSA1s, depress the LF button to set the internal high-pass ﬁlter to 100 Hz. Most powered subs

have their low-pass ﬁlter set at around 100 Hz. If yours is variable, set it at 100 Hz for use with the PSA1.

7. HF (High Frequency) Mode Pushbutton Switch

The HF Mode switch is used to set the relative level of the horn in the PSA1. In normal use, set the

HF switch to Flat. If you are stacking PSA1 cabinets into an array, you may notice an increase in

bass and a lack of treble. This is due to low frequency coupling between the cabinets of the low

frequency drivers. Depress the HF switch on all cabinets to increase the high frequency output of

the cabinets by 3 dB.

The HF switch can also be used in applications where the loudspeakers are situated far from the

audience. The increase of treble will help overcome the natural loss of high frequency due to travel-

ing a greater distance.

Another option is to apply HF boost to only the top box in an array. In this conﬁguration, the un-

boosted bottom box would cover the near ﬁeld and the HF boosted top box would cover the far ﬁeld.

8. Clip and Limit Indicators

The Clip and Limit LED indicators illuminate to guide the user to proper operating levels.

Illumination of the yellow Limit LED indicates that a level has been reached where the PSA1 limit-

ers are reducing the signal internally to prevent damage or distortion. It also indicates that further

increases in input level or increasing the PSA1 Level control position will not appreciably increase

acoustic output. The red Clip LED indicates that the input level is excessive and further increases

in level will cause severe distortion. This happens at very high input signal levels in excess of 13V

peak. The input signal should be reduced at the source immediately until Clip activity ceases.

1 2 3 4 5 6 7 8 9 ... 13 14

Keine Kommentare

Yorkville PSA1 Bedienungsanleitung Seite 4